Attaching Mounting Accessories - NEC MULTEOS M40 Manual Del Usuario

Attaching Mounting Accessories

The display is designed for use with the VESA mounting
system.
1) Attach Mounting Accessories
Mounting accessories can be attached while the monitor
is on the Tabletop Stand in the upright position (Figure
1). Be careful to avoid tipping monitor when attaching
accessories. After accessories are attached, stand can be
removed (Figure 3).
Mounting accessories can be attached with the monitor
in the face down position. To avoid damaging the
screen face, place the protective sheet on the table
underneath the LCD. The protective sheet was wrapped
around the LCD in the original packaging. Make sure
there is nothing on the table that can damage the
monitor.
When using mounting accessories other than NEC
compliant and approved, they must comply with the
VESA-compatible mounting method. NEC strongly
recommends using screws M6 size and 10mm in length.
If using screws longer than 10mm, check the depth of
the hole. (Recommended Fasten Force: 470-635N•cm)
NEC recommends using mounting interface that
comply with UL1678 standard in North America.
This device cannot be used or installed without the
Tabletop Stand or other mounting accessory for sup-
port. For proper installation it is strongly recommend-
ed to use a trained, NEC authorized service person.
Failure to follow NEC standard mounting procedures
could result in damage to the equipment or injury to
the user or installer. Product warranty does not cover
damage caused by improper installation. Failure to
follow these recommendations could result in voiding
the warranty.
VESa Mounting interface
Figure 1
tabletop Stand
Figure 2
table
English-7
Installation
- continued
Protective Sheet
tabletop Stand