Initial Setup - Audio-Technica AT-LP60-BT Instalación Y Funcionamiento

Initial Setup

Assembling the Turntable
The AT-LP60-BT requires some assembly before first use.
IMPORTANT: Do not connect the AC power cable until assembly is
complete.
1. Carefully place the turntable platter on the center spindle,
making certain the platter is fully seated on the spindle.
2. While holding both ends of the red tape ribbon on the
turntable belt, carefully pull the belt over the brass motor
pulley (Fig. 2a). (If the belt drops off, remove the turntable
platter and put the belt back on it, as described on page 7.)
3. Once the belt is seated in the pulley's groove, carefully
remove the ribbon. Make certain the belt is not twisted.
(NOTE: If the belt is not correctly positioned around the
motor pulley, the turntable will not operate. Please double-
check to make sure that the belt is positioned correctly.)
4 Place the turntable mat on top of the turntable platter (Fig. 2b).
5. If desired, the hinged dust cover may be removed. Hold both
sides of the dust cover and pull upward gently and evenly to
detach the cover from the turntable (Fig. 2c). Keep the cover
in a safe, clean place.
6. To re-install the dust cover, guide the dust cover hinges into
the two hinge receptacles located at the back of the turntable
housing.
Setting the Pre-amplifier Selector Switch (PHONO/LINE)
For increased flexibility of use, this turntable has an internal stereo
phono pre-amplifier. The pre-amplifier selector switch (PHONO/LINE)
switch is located on the back of the turntable. If the stereo system you
are using has a PHONO input, set the pre-amplifier selector switch to
the "PHONO" position. If your stereo system does not have a PHONO
input, set the pre-amplifier selector switch to the "LINE" position and
connect the turntable's output cables to the AUX or other high-level
input on your stereo system (described later) (Fig. 3).
The pre-amplifier selector switch does not affect wireless connection.
You can leave the switch in either position when connecting the
turntable to a Bluetooth
receiver device.
Figure 3
Input
jacks
Pre-amplifier
selector
switch
4
PHONO AUX
Figure 2 – Assembling the turntable
2a – Drive belt
Red ribbon
Drive belt
2b – Record mat
45-RPM adapter
Brass motor
pulley
2c – Dust cover removal
Stereo system
White
Red
Brass motor pulley
AC
PHONO LINE
AC