Replace The Filters; Replace The Nanoprotect Activated Carbon Filter And The Nanoprotect Filter - Philips AC4012/00 Manual Del Usuario

7 Replace the
filters
The filter replacement light (
indicates the filters have to be replaced.
Note
• If you remove the front panel for filter
changing while the purifier is switched
on, all lights on the control panel will
be off.
• Once the front panel is placed back to
the purifier, all lights flash twice. Then,
the purifier is off. Press the
switch on the purifier again.
Replace the NanoProtect
Activated Carbon filter
and the NanoProtect
filter
Note
• The NanoProtect Activated Carbon
filter and the NanoProtect filter are not
washable or vacuum cleanable.
Replace both the NanoProtect
Activated Carbon filter and NanoProtect
filter when the light goes on. This light
will be on for approximately 2 weeks.
On the last day of the 2 weeks, the
purifier beeps every 30 minutes to
inform you that the filter needs to be
replaced.
Note
• Insert the filters in the correct position.
• Make sure you place the filters in the
order of NanoProtect filter, NanoProtect
Activated Carbon filter, and finally the
pre-filter.
• Make sure that the side with the tag is
pointing towards you.
EN
10
1
2
)
3
• Do not touch the pleated filter surface,
or smell the filter as it has collected
button to
pollutants from the air.
• Wash your hands after disposing of the
used filters.
4
5
6
7
• Make sure that the side with the two
projections is pointing towards you,
and that all hooks of the pre-filter are
properly attached to the purifier.
8
9
Switch off the purifier and unplug it.
Place your fingers in the recesses
of the side panels and gently pull
the bottom part of the front panel
towards you. Lift the panel out of
the hooks at the top of the purifier
(fig b).
Remove the filters using the tag on
the filter. Take the filters by both
sides and gently deposit them into
the house hold trash bin (fig s).
Note
Remove all packaging material
from the new filters (fig d).
Place the new NanoProtect filter in
the purifier first (fig t).
Then, place the new NanoProtect
Activated Carbon filter in the
purifier (fig u).
Place the pre-filer in the purifier
(fig f).
Note
To reattach the front panel, insert
the top hooks into the top of the
purifier first (1). Then, push the
panel against the body of the
purifier (2) (fig g).
Reset the NanoProtect Activated
Carbon filter and the NanoProtect
filter lifetime (see 'Reset the filter
lifetime counter').