Paslode Cordless Roofing Nailer Operation - Paslode CR175C Manual De Instrucciones

Paslode Cordless Roofing Nailer Operation

DANGER DANGER
The work contacting element and nose will become hot
after prolonged or rapid use.
CAUTION
This tool must be operated in a well ventilated
environment, because the tool exhausts carbon
monoxide similar to a chainsaw or lawn mower.
Exposure to carbon monoxide may cause dizziness,
nausea or unconsciousness.
PRESS WORK – PRESS WORK –
CONTACTING CONTACTING
ELEMENT ELEMENT
AGAINST THE AGAINST THE
WORK SURFACE. WORK SURFACE.
Fan motor starts,
The Cordless Roofing Nailer requires cooling of
fuel is injected into
the motor assembly to operate properly. The fan
combustion chamber
normally provides the necessary air flow to permit
chamber and mixed
continuous operation. Whenever the Cordless Roof-
mixed with air by
the fan. the fan. the fan.
where temperatures will not exceed 120°F (49°C).
After extended periods of continuous use, it may be
necessary to cool the Impulse motor by setting tool
SQUEEZE SQUEEZE SQUEEZE
aside for 10-15 minutes or until the tool operates
TRIGGER TRIGGER TRIGGER
Spark plug ig Spark plug ignites
the fue the fuel/air mixture
driving the piston
COLD WEATHER OPERATION
assembly do assembly down on
Fuel cartridges at cold temperatures lose the
the fastener. the fastener. th the fastener f t r.
required propellant pressure. Bring the tool, fuel
cartridge, and battery above 45 F (7.2°C) by placing
the tool in a heated building or vehicle. Never expose
the tool, fuel cartridge or battery to flame.
RELEASE RELEASE RELEASE
If the tool cannot be warmed to 45°F (7.2°C) or greater,
TRIGGER - TRIGGER - TRIGGER
follow the below steps until the tool reaches it's normal
LIFT TOOL LIFT TOOL LIFT TOOL LIFT TOOL
operational range.
Combustion Combustion Combustion
chamber opens. chamber ope
Warm the fuel cartridge by placing it in an inside pocket
Fan exhausts hot Fan exhausts hot Fan exhausts
of your jacket for several minutes.
gases and cools
internal componets.
It will be necessary to repeat this procedure several
times until the temperature of the tool warms up enough
to operate in it's normal mode.
Once the tool reaches operational temperature the tool
will generate it's own heat and will function normally.
If the tool sits for an for an extended period of time and
cools down it may be necessary to repeat these steps.
Paslode Cordless Roofing Nailer and
Outdoor Weather
Use the Cordless Roofing Nailer outdoors, in dry
weather, when the nailer, fuel cartridge, and battery
are between 45°F (7.2°C) and 110°F (42.3°C).
HOT WEATHER OPERATION
ing Nailer is idle for extended periods, keep the fuel
and tool out of direct sunlight and in surroundings
normally. An overheated tool may not drive nails
completely or may operate erratically.
Load the warm fuel cartridge into the tool. Quickly
depress the tool two times onto the work surface and
hold the tool in the down position after the second
actuation. Wait one or two seconds then pull the trigger.
This action is referred to as "double pumping" the tool.
CAUTION
The Cordless Roofing Nailer should not be used
in the rain or where excessive moisture is present.
The use of the Paslode Cordless Technology under
these conditions may result in damage to tool
components and cause the tool to malfunction.
°
®
13