Paslode CR175C Manual De Instrucciones página 6

1. Eye protection must meet the requirements of ANSI
Standard Z87.1 and should have side shields for
increased protection.
2. NEVER ASSUME THE TOOL IS EMPTY.
Never point the tool at yourself or anyone else.
3. NEVER ENGAGE IN "HORSEPLAY" WITH THE TOOL.
The Cordless Roofing Nailer is not a toy – it is a
tool. Careless and improper use may result in a
serious accident.
4. NEVER CARRY THE TOOL WITH YOUR FINGER ON,
OR SQUEEZING, THE TRIGGER.
This practice may result in the accidental discharge of
a fastener.
5. NEVER OPERATE A MALFUNCTIONING TOOL.
Refer to the servicing or troubleshooting section of this
manual to correct the problem. If the problem cannot be
corrected, stop using the tool and report it to your
supervisor or Paslode
6. DO NOT LOAD FASTENERS WITH THE TRIGGER
AND/OR WORK CONTACTING ELEMENT PRESSED
IN.
A fastener may be accidentally discharged.
WARNING
Always wear EYE and
EAR safety gear when
working with or in the
vicinity of the Paslode
Cordless Roofing Nailer.
representative.
®
Safety Instructions
7. NEVER REMOVE OR DISABLE THE WORK
CONTACTING ELEMENT.
This device helps reduce the possibility of accidental
fastener discharge by preventing the tool from operating
until it is completely against the work surface.
NEVER operate the tool if the work contacting element
is not working properly.
8. ALWAYS POINT THE TOOL AWAY FROM YOURSELF
AND OTHERS WHEN CLEARING JAMS OR REMOVING
FASTENERS.
9. NEVER OPERATE THE CORDLESS ROOFING
NAILER IF PARTS ARE LOOSE, DAMAGED OR
MISSING.
10. DO NOT DRIVE FASTENERS INTO KNOTS OR ON
TOP OF OTHER FASTENERS.
A fastener may ricochet and cause serious injury.
11. OPERATE THE TOOL ONLY ON THE WORKPIECE.
WARNING
The Paslode Cordless
Roofing Nailer should be
operated only when it is
in contact with the work
surface.
5