Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TOOL INSTALLATION
Your Paslode tool comes ready for immediate use
®
and can be installed by following these steps:
1. SAFETY - All tool operators and their immediate
supervisors must become familiar with the operator
safety instructions before operating the tool. The
instructions are on page 4 of this manual.
2. Included with each tool are one copy of this
Safety and Maintenance manual and one copy of
the Tool Schematic. Keep these publications for
future reference. An ownership registration card is
also included. This card must be completed and
returned to Paslode immediately to register your
®
ownership.
3. The plastic cap in the air inlet of the tool must be
removed before the male fitting is installed. The t-
ting must be a male pneumatic type that discharges
the air from the tool when the air line is disconnected.
4. Install a filter/regulator/lubricator unit, with a
gauge as close as practical to the tool, preferably
within ten feet. Refer to the Air Systems section of
this manual for air hose requirements and lengths.
In general, no other special installation is required.
5. If the operator is working at a bench or table,
it is usually best to run the air line underneath the
bench. A small tray under the benchtop can hold
the fastener supply and the tool when not in use.
6. If this tool does not work when it is first connect-
ed, do not try to make repairs. Call your Paslode
representative immediately.
TOOL OPERATION
Depth of Drive Adjustment
The depth of drive adjustment can be adjusted
two ways.
1. One way is to adjust the air supply to provide
enough drive to meet the proper depth for the
application without exceeding manufactures recom-
mended operating pressure of 120 PSI.
Tools with a Depth of Drive
Adjustment
2. The depth of drive adjustment is made by turn-
ing the thumbwheel on the work contact element.
If the tool is overdriving (the fastener head is
driven below the work surface), the work con-
tact element should be moved downward. If
the fasteners stand up (the head not flush with
the surface), the work contact element should
be moved up.
Adjust the work contact element until the fas-
tener head depth meets job requirements.
®
(On tools equipped with this feature)
5
WORK
CONTACT
ELEMENT
ROTATE
THUMBWHEEL
IN EITHER
DIRECTION
Capítulos
Tabla de contenido
