Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Normal Stage of Operation
S
Y
M
P
T
O
M
Tool operates properly, but fasteners do not
drive fully.
Tool operates properly, but fasteners are
sometimes over-driven, and sometimes
under-driven.
Tool operates, but no fastener is driven.
Tool operates erratically or appears to be
losing power - tool indicator light is green.
Tool operated and drove fasteners, but
driver blade did not return to up position.
Nose does not drop after tool cycles.
If tool will not operate after following the above service directions, return the tool to an authorized Paslode
representative for service.
For technical support call 1-800-222-6990 or visit our web site at www.paslode.com.
To purchase parts, visit our website at www.itwconstructionparts.com.
18
P
O
S
S
B I
L
E
P
R
O
B
L
Work-contacting element requires adjustment.
Fuel cell is low.
There may be loss of seal in combustion
chamber.
Work-contacting element is not adjusted
properly for the type of material being
fastened.
Wrong fasteners being used.
Nail tray in wrong position.
Jammed fastener.
Fuel cell is low.
Spark plug wire is loose.
Air filter is dirty, causing tool to overheat.
Tool is dirty.
Built-up dirt and debris on driver blade or in
nosebore.
Tool is dirty.
Work-contacting element is bent, or is dirty.
An Illinois Tool Works Company
888 Forest Edge Drive
Vernon Hills, Illinois 60061
www.paslode.com
E
M
S
Adjust work contacting element.
Check fuel cartridge and replace as required.
Press work contacting element against the
workpiece for one minute. Pull trigger. If
fastener does not drive, there is a leak that
requires service.
Adjust work-contacting element. Readjust
as requir ed when material density or thick-
ness of material being fastened changes.
Use only fasteners meeting Paslode spec-
ifications Check fasteners and applications
section for fastener types and sizes recom-
mended for use in the Paslode Cordless
Roofing Nailer.
Adjust nail tray to proper position.
Clear jam.
Check fuel cell.
Check spark plug wire.
Remove air filter and clean. Use soap and
water to remove stubborn debris.
Clean tool.
Clean driver blade and nose bore with de-
greaser cleaner.
Clean tool.
Clean nose area or replace work-contacting
element.
S
E
R
V
C I
E
®
®
Tabla de contenido
