Charging Times - Paslode CR175C Manual De Instrucciones

Battery and Charging System
The Paslode Cordless tools come with a recharge-
able battery and its own charging system. This
charging system is the only one that will work with
Paslode batteries (either round or oval ). The first
step in preparing a new tool for operation is to fully
charge the battery. New batteries are shipped dis-
charged and must be charged prior to first use.
Batteries will take 5 minutes to 2 hours (time will
be dependant on the amount of discharge of the
battery) to recharge.
Important Charging Notes
CHEMICAL/EXPLOSION
HAZARD
Read ALL instructions be-
fore charging or using bat-
tery. Failure to follow ALL
instructions may result in
fire, severe burns, or re-
lease of toxic materials.
Battery Disposal:
The Paslode batteries contain cadmium and must be
recycled or disposed of properly. It is illegal in some
areas to place a nickel-cadmium battery into the trash
or solid waste stream. You may contact your local
recycling center for information on where to return the
spent battery or call 1-800-822-8837 for information on
Ni-Cd battery recycling in your area.
Battery and Charging System
Charging Instructions
1. Remove wall mount unit with the orange label from
2. Remove the battery from tool or case and insert
Warning
3. After charging is complete, the red light will go out
4. Unplug the wall mount unit from the charger and

CHARGING TIMES:

CHARGING DON'TS:
1. Do not charge battery outdoors or in temperatures
2. Do not allow metal objects to come in contact with
3. Do not puncture or attempt to open battery case or
4. Do not store battery where it will be subjected to
5. Do not incinerate battery.
6.
7. Do not immerse the battery in water.
Charging System Accessories:
Battery - Part No. 404717
Battery Charger Kit - Part No. 900200
Wall Mount Transformer* - Part No. 900477
Battery Charger Base* - Part No. 900476
Automotive Adapter* - Part No. 900507
* Cannot use with previous (gray in color) charging system
components.
the tool case and plug into a 120V AC outlet. Set
orange charger on a stable surface and insert wall
mount unit's plug into plug receptacle on the back
of the charger (see picture). A green light indicates
power is on and charger circuit is ready.
terminals down into charger. The red light will come
on indicating that the battery is charging and the
green light will go out.
NOTE
If battery is completely discharged, the red light and
the green light may flash back and forth.
This safety feature slowly recharges the battery until
it is ready to accept the full charging current. If the
red and green lights continue to flash after 25 min-
minutes, replace the battery.
and the green light will come on, indicating that the
battery is fully charged. The charger will keep the
battery at full charge until it is removed.
remove the wall mount unit from the 120V AC outlet.
First charge (new battery)
Discharged Battery
below 40°F (5°C).
battery terminals.
cells.
temperatures above 120°F (49°C).
Do not use a defective battery charger, one that
over-heats and/or smokes when plugged in.
2 hours
5 minutes to 2 hours
7