Tabla de contenido
Idiomas disponibles
Idiomas disponibles
HALOGEN BULBS
This range hood requires two (2) halogen bulbs
(Type T3, 12V, 20Watt max, G-4 Base).
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
NOTE: Avoid touching metal bars simulta-
neously with metal objects. Doing so will
cause fuse to open and lamp operation
failure.
To change bulbs:
1. Unscrew the mounting screws and take off
the lamp to handle more easily. Fig. 2.
2. Open the cover by prying from the proper
slots. - DO NOT ROTATE. CAUTION:
BULB MAY BE HOT! Fig. 3.
3. Replace with a bulb of the same type (T3,
12V, 20Watt max, G-4 Base). Do not touch
replacement bulb with bare hands!
FUSE REPLACEMENT
IF LIGHTS FAIL TO OPERATE, DISCONNECT
THE POWER AT THE SERVICE ENTRANCE.
CHECK THE FUSE AND REPLACE IF NEC-
ESSARY.
1.
Remove the grease filter. Fig. 4.
2.
Unscrew the fuse holder cap and remove
the fuse.
3.
Replace the fuse with the same size and
amperage (5 x 20mm, 4 amp, 125 volt).
4.
Reinstall the filter and connect power at
service entrance.
MOUNTING SCREW
- 5 -
FIG. 2
FIG. 3
FUSE
FIG. 4
Tabla de contenido
