Best IS502 Manual De Instrucciones página 10

6. Position the bottom of the lower deco-
rative flue near the electrical system
plate. Fig.13.
7. Assemble the switch to the mounting
brackets located inside the lower
decorative flue. Make sure switch
buttons align with holes in the flue,
then secure with (2) sheet metal
screws ( the screws are already
tightened to the bracket). Fig.13.
SUPPORT
FRAME
SWITCHES
SHEET METAL
SCREWS
8. Run lamp cables to the oval holes
located on both sides of the lower
decoative flue. Feed one wire
through each of the oval holes and
tape each to the outside of the flue.
Fig. 13.
9. With the switch aligned with the sup-
port frame edge marked "FRONT",
carefully lift the flue over the support
frame. Fig. 14.
10. Lower the flue into position. Tuck
excess cable length inside the flue
as it's lowered into position. Fig.14.
FRONT
EDGE
SWITCH
11. Support hood under glass to gain
access to blower.
Remove the grease filter (Fig. 15).
Fasten the lower decorative flue to
the hood using (3) sheet metal
screws. Fig.15a.
POWER
CABLE
TAPE
SCREWS
FIG. 13
SHEET METAL SCREWS
12. Reinstall the filter and secure with
(2) knobs (the 2 screws removed
LOWER FLUE
beforehand should not be re-used).
FIG. 14
- 10 -
FILTER
FIG. 15
LOWER FLUE
FIG. 15a