Step 7: Connecting The Tdm-Nc1 To The Network - Sony TDM-NC1 Manual De Instrucciones

To connect/disconnect the unit
Connecting
1
Connect the DIGITAL MEDIA PORT cable
of this unit to the AV system with DIGITAL
MEDIA PORT interface (Sony DAV series,
etc.). Make sure the AV system is turned off
before connecting.
Note
According to your area's TV system, switch the
NTSC/PAL selector on the bottom of the unit.
NTSC/PAL
selector
2
Turn on the AV system connected to the
unit, and switch the AV system function to
DMPORT.
Disconnecting
Before disconnecting, turn off the AV system.
Otherwise, this unit cannot backup settings
correctly.
STEP 7: Connecting the
TDM-NC1 to the network
Select your desired network setting from the
following three options.
– Wired setting , select Case A.
– Wireless setting (but the unit is not installed
near computer) , select Case B.
Note
You can set up the wireless setting by starting your
computer web browser. See Case C (page 18). Also, if
your wireless access point settings are applied under
one of the following settings, you need to select Case
C.
– If you set wireless network key (WEP key) to other
than "WEP key No. 1".
– If you set the access point's SSID not to transmit
(stealth mode).
MENU
m/M
ENTER
./>
+/–
GB
16