General Power Tool Safety Warnings - Makita JR1000FT Manual De Instrucciones

ENGLISH (Original instructions)
1. Clamping screw
2. Cover
3. Shoe
4. Hex wrench
5. Shoe
6.
Switch lever
SPECIFICATIONS
Length of stroke
Max. cutting capacities
Strokes per minute (min
Overall length
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Intended use
The tool is intended for sawing wood, plastic, metal and
building materials with a strong impact. It is suitable for
straight and curved cutting.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Recipro saw safety warnings
1. Hold the power tool by insulated gripping
surfaces, when performing an operation where the
cutting accessory may contact hidden wiring or its
4
Explanation of general view
7. Speed adjusting dial
8. Lower
9. Higher
10. Lamp
11. Holder cover
12. Blade clamp
Model
Pipe
Wood
-1
)
Net weight
Safety class
own cord. Cutting accessory contacting a "live" wire
ENE021-1
may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
2. Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
ENF002-2
the workpiece by hand or against your body leaves it
unstable and may lead to loss of control.
3. Always use safety glasses or goggles. Ordinary
eye or sun glasses are NOT safety glasses.
4. Avoid cutting nails. Inspect workpiece for any
nails and remove them before operation.
5. Do not cut oversize workpiece.
6. Check for the proper clearance beyond the
workpiece before cutting so that the blade will not
GEA010-2
strike the floor, workbench, etc.
7. Hold the tool firmly.
8. Make sure the blade is not contacting the
workpiece before the switch is turned on.
9. Keep hands away from moving parts.
10. Do not leave the tool running. Operate the tool
only when hand-held.
11. Always switch off and wait for the blade to come
to a complete stop before removing the blade from
the workpiece.
12. Do not touch the blade or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
13. Do not operate the tool at no-load unnecessarily.
14. Always use the correct dust mask/respirator for
the material and application you are working with.
15. Some material contains chemicals which may be
GEB164-1
toxic. Take caution to prevent dust inhalation and
skin contact. Follow material supplier safety data.
13. Fixed position
14. Released position
15. Saw blade
16. Blade clamp
17. Front holding area
18. Collar
JR1000FT
14 mm
25.4 mm
55 mm
0 - 4,800
345 mm
1.6 kg
/II