ZIV IDV-A Serie Manual De Instrucciones página 720

Tabla de contenido

PRINCIPAL MODULE

POWER SUPPLY

El contenido del presente documento es propiedad de ZIV Aplicaciones y Tecnología, y no puede

ser reproducido ni copiado sin la expresa autorización escrita de ZIV Aplicaciones y Tecnología .

The contents of this document belong to ZIV Apli caciones y T ecnologia and may not be

reproduced or copied without express written authorization from ZIV Aplicaciones y Tecnologia .

BUTTONS LEDS

NOTE 1: TERMINAL H10 SHOULD BE CONNECTED TO POSITIVE WHEN ANY OF THE INPUTS

IN3, IN4 ARE BEING USED FOR THE BREAKER COIL SUPERVISION FUNCTION.

NOTE 2: TERMINAL I4 SHOULD BE CONNECTED TO POSITIVE WHEN ANY OF THE INPUTS

IN6 OR IN7 ARE BEING USED FOR THE BREAKER COIL SUPERVISION FUNCTION.

NOTE 3: TERMINAL I8 SHOULD BE CONNECTED TO POSITIVE WHEN ANY OF THE INPUTS

IN8 OR IN9 ARE BEING USED FOR THE BREAKER COIL SUPERVISION FUNCTION.

NOTE 4: VA, VB, VC AND VN ANALOG INPUTS CAN BE CONNECTED TO ANY OF THE WINDINGS.

CONNECTION SHOWN IS ONLY ONE EXAMPLE. VA, VB, VC AND VN CAN BE CONNECTED

AS A L-L OR L-N VOLTAGE.

NOTE 5: CONFIGURATION SHOWN (WYE AND OPEN-DELTA) IS ONE CONNECTION

EXAMPLE, A REFERENCE FOR OTHER POSSIBLE CONFIGURATIONS.

NOTE 6: NEUTRAL CONNECTION OF EACH WINDING DEPENDS ON GROUP CONNECTION AND IT IS

POSSIBLE TO ASSIGN IG-1 AND IG-2 ANALOG INPUTS TO ANY OF THE WINDINGS.

NOTE 7: ALL OUTPUTS ARE CONTROLLER

NOTE 8: NUMBER OF WINDINGS SETTING

"ATENCION" "WARNING"

Continua en Hoja:

Continued on sheet:

Capítulos

Tabla de contenido