Instructions For Replacing The Water Bottle - Honeywell HWBL1013 Serie Manual De Instrucciones

8. INSTRUCTIONS FOR REPLACING THE WATER BOTTLE

WARNING: Only use 3 or 5 gallon water bottles on this water cooler.
WARNING: Please make sure to turn OFF the unit when the hot and cold water tanks are
empty. Always have water inside the tanks before turning ON any switch.
• Remove the cap from the 3 or 5 gallon water bottle.
• Open the cabinet door and place the water bottle near
the cabinet. The 5 gallon bottle weights approx. 40
lbs, please seek help if you are unable to move the
water bottle.
• Install the water bottle pump connection as explained
in section INSTALLING YOUR WATER COOLER FOR
THE FIRST TIME
• Carefully place the bottle inside the cabinet and close
the door.
• Plug the unit into the electrical outlet and allow the
water to fill all tanks inside the unit for approximately
5 minutes.
• Push in on all water taps to make sure water flows
from all faucets.
• Turn ON the cold and hot water switches to allow the unit reach the minimum cold and
hot water temperatures. This will take approximately 30 to 45 minutes and the indicator
lights will turn OFF.
• Test the water temperatures by pushing once again on the water taps
• Your water cooler is now ready for use.
10