Adjusting Air Pressure; Loading Nails; Nailer Operation - Metabo HPT NT 50AE2 S Instrucciones Y Manual De Seguridad

English

ADJUSTING AIR PRESSURE

WARNING
Adjust the air pressure
operating pressure 70 – 120 psi (4.9 – 8.3 bar
5 – 8.5 kgf/cm ) according to the length of nails and the
2
hardness of workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.

LOADING NAILS

WARNING
When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Lightly press the stop lever and gently pull out the
magazine cover.
Magazine cover
Stop lever
(2) Set nail strip into the magazine and keep the points of
nails in contact with Groove.
Nail strip
Magazine
NOTE
The nails shown in page 10 can be loaded onto
the side guide groove of the magazine without any
adjustment.
Always keep the points of nails in contact with
Groove.
14
000Book_NT50AE2_US.indb 14 000Book_NT50AE2_US.indb 14
Do not exceed
120 psi (8.3 bar
8.5 kgf/cm ).
2
at recommended
(3) Slide the nail strip into the blade guide.
(4) Confi rm that nail strip is placed with side guide
grooves and Groove properly, then push the
magazine cover forward to be latched.

NAILER OPERATION

Read section titled "SAFETY"(pages 4 – 8).
Press
Pull out
Groove
Magazine
Side guide
groove
Nail
Gap
Groove
Nail strip
Blade guide
DANGER
Operators and others in work
area MUST wear safety
glasses with side shields
which conforms to ANSI
Z87.1 specifi cations.
Ordinary eyeglasses do not
provide adequate protection.
WARNING
Only person who have read
and understand
MANUAL should operate the
Nailer.
NEVER point tool at yourself
or others in work area.
Keep fi ngers AWAY from trigger when not
driving nails to avoid accidental discharge.
Know and understand what trigger system
you are using.
Please read and understand "METHODS OF
OPERATION" found below.
this
2018/03/22 15:09:05 2018/03/22 15:09:05