Tabla de contenido
Å
1
ı
1
CARBURETOR
19. Install:
1
NOTE:
Install the breather hose to the carburetor so
that the hose does not bend near where it is
installed.
Å
WR426F
ı
WR400F
1
Accelerator pump timing adjustment
Adjustment steps:
NOTE:
In order for the throttle valve height a to
achieve the specified value, tuck under the
throttle valve plate 1 the rod 2 etc. with the
same outer diameter as the specified value.
Fully turn in the accelerator pump adjust-
G
ing screw 3.
Check that the link lever 4 has free play
G
b by pushing lightly on it.
Gradually turn out the adjusting screw
G
while moving the link lever until it has no
more free play.
* Except for USA
4 - 19
Carburetor breather hose 1
G
Refer to "CABLE ROUTING DIA-
GRAM" section in the CHAPTER 2.
Throttle valve height:
WR426F: 3.10 mm (0.122 in)
*2.25 mm (0.089 in)
WR400F: 6.60 mm (0.260 in)
ENG
Tabla de contenido
