Battery Change - unGer Stingray Manual Para El Usuario

3.4 Battery Change

• Two AA batteries are required.
• The battery compartment is located under the pouch.
• Remove the pouch from the compartment
during battery change.
• Unscrew the battery lid.
• Remove old batteries and dispose of in accordance with
applicable federal, state/provincial and local regulations.
• Replace with new batteries. Pay attention to the correct
orientation of each battery.
• Close the compartment and secure the lid with the screw.
• Do not expose batteries to direct sunlight, heat or fire.
There is a risk of explosion!
4.0 Use
Every pole section has its own activation button to start the pump.
1. Before beginning a new cleaning job or when using a new pad,
press the trigger or activation button for five seconds to pre-
moisten the pad. Use circular motions to dampen the entire
surface of the pad. During the cleaning process, use as little
liquid as possible. If you need to re-moisten the pad, hold the
trigger or activation button for about one second.
You don't need to use much cleaning liquid. Because the pad is
made from high performing microfiber material, it only needs
to be damp to achieve the best cleaning results.
2. When window cleaning, start by cleaning the window frames.
Beginning in one corner, clean the outer edge of the window
being sure to keep contact with the frame.
3. Once outer area is cleaned, in all four corners and along
all four edges, clean inner area of window.
2
6
Installation/Use
1
5x
3
or