Foot Switch Operations In Preset Or Manual Modes; Connecting To A Computer Via Usb; About The Amp Models And Effect Types; Amp Models - Vox VT20X Manual De Usuario

Specifying the VFS5 operation
Hold down the switch with the same number as the selected channel for at
least 3 seconds to perform the same operation as in preset programs mode
or manual mode; the effect selection buttons blink briefly. To return to the
previous operation, hold down the CH3 switch for at least 3 seconds. (The
BANK and channel buttons blink briefly.)

Foot switch operations in Preset or Manual modes

Tap to set the speed/time (CH3 switch)
Press the CH3 switch on the VFS5 to set the speed and time for the
PEDAL2 effect. The interval between two presses of the switch will be
set as the speed and time.
Effect on/off (CH1, 2, 4 switches)
Press the CH1, CH2 or CH4 switch on the VFS5 to switch on/off the
corresponding PEDAL1, PEDAL2 or REVERB effect.

Connecting to a computer via USB

By connecting the amp to a computer using a commercially available
USB cable, the Editor/Librarian software on the computer can be used to
manage programs and customize amps/effects.
The VT20X/VT40X can also be connected to an iOS device (iPad or iPhone)
by using the Apple USB camera adapter.
Install a USB-MIDI driver in order to use the Editor/Librarian software
Tip
on the computer. Download the newest versions of the drivers and
software from the VOX website (www.voxamps.com).
For details on using the Editor/Librarian software, refer to the
Tip
documentation included with the software.

About the amp models and effect types

This section provides details on the amp models, the various types of
PEDAL1, PEDAL2 and REVERB effects as well as noise reduction.
Unnatural distortion may occur, depending on the amplifier and
effector settings. If this occurs, adjust the amp and effect parameters.
If a parameter not available on the top panel is changed in the
Editor/Librarian software, the tone may become quite different from
the original amp model or effect type.

Amp models

Using the Editor/Librarian software, you can select more amp models
Tip
than those listed below, and you can store your favorite amp models
at USER A, USER B and USER C.
In the factory default setting, BOUTIQUE CL, BRIT 1959 and BOUTIQUE
Tip
METAL are stored at USER A, USER B and USER C, respectively.
1 . DELUXE CL
This dual channel, 22W blackface 60's design used 6V6 power tubes and
a tube-driven spring reverb to produce a big sound at a lower wattage.
Our modeling is based on the Vibrato channel of this amp.
2 . TWEED 4x10
This models a 4x10" combo amp from 1959 that was originally designed
for bass guitar. Its smooth and crisp overdrive sound will respond
sensitively to your picking dynamics and to the volume of your guitar.
3 . VOX AC30
This models the Normal channel of the AC30.
The clear high range of the Celestion alnico "Blue" speaker, as well as
the rich midrange, deliver a captivating clean sound.
4 . BOUTIQUE OD (BTQ OD)
This models the overdrive channel of a high-quality amp that was known as the
Overdrive Special, which was produced only by special order. The wonderful
sustain obtained by raising the GAIN control is smooth and soulful.
- 10 -