CONNECTIONS, CONTROLS, AND INDICATORS:
BELT PACk RECEIVER:
4
LC DISPLAY
Backlit LC Display. The back light automatically
turns off after about 30 seconds if no control
buttons are pressed; the back light is turned on
when any of the control buttons is selected. See
Chapter "System Setup".
5
LOW BATT LED
LED lights when the battery charge is low. Please
replace the batteries as soon as possible.
6
RF SIGNAL LED
Lights up briefly when you switch on. Lights up
when a HF signal is present. Radio frequency of
both transmitter and receiver must match.
1
ON/OFF - VOLUME
On / Off switch and volume control. To switch on,
turn the knob to the right (clockwise) past the
snap-in point. To switch off, turn the knob to the left
(counter clockwise) past the snap-in point. Turning
the knob to the left decreases the volume; turning it
to the right increases the volume. To avoid hearing
damage, set the volume to minimum before using
10
the earphones/headphones, then slowly increase
the volume. Caution: high volume can cause
permanent hearing damage.
2
PHONES
Earphone/headphone connector 3.5 mm stereo jack.
3
ANTENNA
7
ARROW UP BUTTON
See Chapter "System Setup".
8
ARROW DOWN BUTTON
See Chapter "System Setup".
9
ESC-BUTTON
Press this button to return to the main menu.
10
SET BUTTON
See Chapter "System Setup".
9