SEVERIN KM-3890 Instrucciones De Uso página 13

the appliance has been switched off
and disconnected from the mains.
∙ Caution: After switching off, always
wait until the motor has come to a
complete standstill. Do not touch any
moving parts.
∙ Press the release button (PUSH) to
release the drive head. Tilt the head
upwards until it is heard locking safely
into place.
∙ Fit the main bowl and lock it by turning it
clockwise.
∙ Place the splash-guard ring onto the bowl
with the fi ller opening to the left.
∙ When fi tting the attachments, ensure that
the pin on the mounting fi ts safely into the
corresponding recess in the attachment.
∙ Push the attachment all the way up, then
lock it by turning it anti-clockwise (about
90°).
∙ Caution: If an attachment should touch
the splash-guard ring when being fi tted,
lower the tilt-arm again and switch the unit
briefl y on; this will bring the drive head in a
centred position inside the bowl.
∙ Put the ingredients into the bowl.
∙ Press the release button. Tilt the head
downwards until it is heard locking into
place.
∙ Insert the plug into a wall outlet.
∙ Slowly turn the rotary control to the
required speed setting.
∙ The fi ller opening in the splash-guard
ring allows you to add further ingredients
during the stirring or kneading process.
∙ Switch the appliance off and remove the
plug from the wall outlet after use,
∙ Press the release button (PUSH) to
release the drive head. Tilt the head
upwards until it is heard locking safely into
place.
∙ Caution: Check the position of the
attachments before tilting up the drive
head: if they are not in a centred position,
briefl y switch the unit on again to centre
the drive head inside the bowl.
∙ Push the attachment upwards all the
way, then unlock it by turning it clockwise
(about 90°) and remove it from its
mounting.
∙ Remove the splash-guard ring.
∙ Unlock the bowl by turning it anti-
clockwise and remove it.
Using the blender
Caution: When using the blender
attachment, both the main bowl and
splash-guard ring must be fi tted. Do not
reach into the stirring bowl with your
hands or fi ngers
Appropriate speed levels
∙ Settings 1 to 4 are suitable for slow
blending and stirring.
∙ Settings 5-6 are suitable for chopping,
mixing and pureeing.
Blender operation
∙ Fit the blender jug in such a way that the
arrow mark on the jug is properly aligned
with the open-lock symbol ( ). Lock the
jug by turning it clockwise, so that the
arrow mark on the jug is aligned with the
closed-lock symbol ( ).
∙ Put the liquid ingredients into the blender
jug, which has a maximum capacity of
around 1,500 ml. To prevent possible
spillage when processing foamable or thin
liquids such as milk, do not fi ll the jug over
the 1,000 ml mark.
∙ Place the lid on the jug so that the pouring
13