Idiomas disponibles
Idiomas disponibles
WARNING:
WEAR A DUST MASK IF BLOWING CREATES
DUST THAT MIGHT BE INHALED.
1. Verify that the power cord is disconnected
from the outlet.
2. Press the blower release button
lift the blower from the lid.
3. Attach the blower adaptor
22
to the blower port
tighten them.
4. Attach the car nozzle or in ation nozzle
(depending on the blowing requirements) to
the blower wand
22
the connection.
5. Plug the cord into the wall outlet. The blower
is ready for use.
6. Turn the unit "ON" by pushing the switch from
position "O" to position "I" or "II".
EMPTY THE TANK
WARNING:
To reduce the risk of injury from accidental
starting, unplug power cord before emptying
the dust tank.
1. Remove the power head blower assembly
of the wet/dry vac by pulling outward on the lid
latch located on each side of the vac.
Lift off the the blower assembly.
and
5
and blower wand
25
. Twist slightly to
4
. Twist slightly to tighten
2. Dump the tank contents into the proper
waste disposal container.
3. Liquids may be emptied through the tank
drain. To empty, turn the Unit off and
remove the plug from the wall outlet.
Remove the drain cap and deposit the
liquid waste contents in a suitable drain.
After tank is empty, return the drain cap
to its original position. To continue use,
plug the cord into the wall outlet and
turn the unit on.
CARE AND MAINTENANCE
FILTER REPLACEMENT
WARNING:
To reduce the risk of injury from accidental
starting, unplug power cord before changing or
cleaning the lter. The lter should be cleaned
often to maintain peak vac performance.
WARNING:
Do not remove lter cage and oat. The oat
prevents water from entering the impeller and
damaging the motor. The cage prevents ngers
from touching the moving impeller.
NOTICE:
To avoid damage to the impeller and motor,
always reinstall the Clean Connect™ lter before
using the vac for dry pickups and wet pickups.
7
ENGLISH
