Jocel JLLI023124 Manual De Instrucciones página 83

Idiomas disponibles

Idiomas disponibles

FILL IN THE DETERGENT
Fill the detergent dispenser with detergent.
The marking indicates the dosing levels, as illustrated on
the right:
1. The place of main wash cycle detergent placed; "MIN"
means approximately 20g of detergent.
2. The place of pre-wash cycle detergent placed,
approximately 5g of detergent.
Please observe the manufacturer's dosing and storage recommendations as stated on the
detergent packaging.
Close the lid and press until it locks in place.
If the dishes are heavily soiled, place an additional detergent dose in the pre-wash detergent
chamber. This detergent will take effect during the pre-wash phase.
NOTE:
You find information about the amount of detergent for the single programme on the last
page.
Please be aware that according to the level soiling and the specific hardness of water,
differences are possible.
Please observe the manufacturer's recommendations on the detergent packaging.
DETERGENTS
There are 3 sorts of detergents
1. With phosphate and with chlorine
2. With phosphate and without chlorine
3. Without phosphate and without chloride
Normally new pulverized detergent is without phosphate. The water softener function of
phosphate is not given. In this case we recommend to fill salt in the salt container even when
the hardness of water is only 6 dH. If detergents without phosphate were used in case of
hard water often white spots appear at dishes and glasses. In this case, please add more
detergent to reach better results.
Detergents without chlorine do only bleach a little. Strong and coloured spots will not remove
completely. In this case, please choose a programme with higher temperature.
USE OF "AUTOMATIC DOOR OPEN" FUNCTION:
For models with automatic door opening function, except pre-washing, all washing
procedures (excluding economic washing) at the end of the program, the automatic door
opener starts to work and opens the door. Automatic door opening for economic washing
starts to work in the drying stage.
83
loading