Idiomas disponibles
Idiomas disponibles
PROGRAMMING THE MAIN PARAMETERS
Programming is usually performed in-house. To access this programme for controls or modifications a password
must be requested to our after-sales service
After switch-on, when Press + is displayed, hold down
Prog until parameter page is displayed.
It is possible to enter the parameter environment,
even from status page.
PARAMETER PAGE
Use Prog, + and - keys to set:
um : unit of measurement.
ton : time (sec) of piston pulse.
toff : time (sec) of pulse-to-pulse pause.
step : number of pulses to output to piston.
Pt
: potentiality.
m2 : set 1 for outlet valve.
set 0 for closing valve.
f : Set 1 for electric limit switch
TYPE OF STRUCTURE
Press + and - keys to display and choose the type of
structure used.
DATA OF STRUCTURE CHOSEN
It is possible to enter hose length, ovalization and hose
diameter.
"USER" STRUCTURE
If the "user" structure is
used, it is possible to enter:
diameter of the roller ,
roller width and number
of teeth of rack.
um – Unit of measurement.
Set 0 to measure in metres.
Set 1 to measure in feet.
ton - Time (sec) of pulse to piston. If time is dcreased,
stroke is shorter and closing movement is slower.
toff - It is time (sec) of pulse-to-pulse pause.
step - It is the number of pulses to be sent to piston.
Pt - Potentiality.
m2 - Set 1 for outlet valve.
Set 0 for closing valve.
f - Set 4 to enable the pressure switch
EN
20
