Idiomas disponibles
Idiomas disponibles
Before you call for service...
NOISE
Washer is noisy
OTHER
Labels on the exterior
of the washer will not
peel off cleanly
16
Possible Causes
Washer is uneven
Washer load is
unbalanced
Shipping rod is still assembled
in unit
Washer is sitting too close
to wall (causes knocking
during cycle)
PerfecTemp feature
is being used
Possible Causes
Occasionally the adhesive
used on the labels does
not release cleanly
What To Do
• To level the front of the washer, adjust the front leveling
legs by rotating the individual leg in the proper direction
for up or down. To level back of washer, lift back of
machine 4" (11 cm) and set down.
• Press PAUSE to stop the washer, open the lid and
redistribute the load evenly. Close the lid and press
START.
• To remove shipping rod from washer, pull yellow tag and
attached rod from the bottom right hand side of washer.
• Pull washer away from the wall; about 4" (11 cm)
is needed.
• This is normal. PerfecTemp turns water valves off and on
to adjust water temperature.
What To Do
• Use a hair dryer set at the lowest heat setting, directing
the air at the label for a short amount of time. This will
release the adhesive easily, without damaging the surface
of the washer.
