Idiomas disponibles
Idiomas disponibles
■
Automatic operation
(auto changeover)
This function is available only for use in combination
with a heat recovery model outdoor unit. If this function
is used with another model of outdoor unit, "A" (Auto)
appears on the remote controller but the automatic
operation is disabled.
Start
SWING
1
START/STOP button (
Press this button to start the air conditioner
2
Mode select button (MODE)
Select A.
3
Temperature button (
Set the desired temperature.
4
Fan speed button (FAN)
Select one of
LOW
, MED
+
The
OPERATION lamp on the display panel
●
of the indoor unit lights, The operating mode is
selected in accordance with the room temperature
and operation starts after approximately 3 minutes.
If the "A" mode is uncomfortable, you can select
●
the desired conditions manually.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
CAUTION
Disagreement in operation mode
If you select AUTOMATIC OPERATION in a model
with no auto-changeover (cooling/heating) control
setting or if you select HEAT in a Cool Only model,
lamp lights up and
with an alarm sound (pi, pi) from the air conditioner
due to disagreement in operation mode. Change the
operation mode with the MODE button on the wireless
remote controller. This disagreement indication cannot
be deleted by the wired remote controller.
FAN
)
)
, LOW
, MED
+
, HIGH
.
)
and
lamps blink alternately
– 8 –
EN
8-EN
