Idiomas disponibles
Idiomas disponibles
■
Wireless remote controller
A-B selection
Using 2 wireless remote controllers for the respective
air conditioners, when the 2 air conditioners are
closely installed.
Wireless remote controller B setup
1. Push the temporary operation button to start the
air conditioner.
2. Point the wireless remote controller at the indoor unit.
3. Push and hold
button on the wireless remote
CHK
controller by the tip of the pencil.
"00" will be shown on the display.
4. Push MODE
button during pushing
"B" will be shown on the display and "00" will be
disappear and the air conditioner will turn OFF.
The wireless remote controller B is memorized.
NOTE
Repeat above step to reset wireless remote
●
controller to be A.
The wireless remote controllers do not display "A".
●
The factory default of the wireless remote
●
controllers is "A".
9
Operating air conditioner without remote
controller
In the following cases, the air conditioner can be operate without remote controller with temporary operation
button on the signal receiving unit.
The battery in the remote controller expired.
●
A trouble occurred on the remote controller.
●
The remote controller has been lost.
●
1
2 ,
1
Start
Push temporary operation button.
The operation mode is the one last selected.
●
If you want to change it, turn the power off and
then on, and push the temporary operation
button again.
2
Stop
Push temporary operation button once more
"00" Display
.
CHK
– 14 –
"B" Display
EN
14-EN
