Idiomas disponibles
Idiomas disponibles
ENGLISH
Shrink Reel
Shrink Reel
Motor Location on Left
Motor Location on Left
Water
Water
Pool Cover
Pool Cover
Motor
Motor
Expand Left Reel
Expand Left Reel
Motor Location on Right
Motor Location on Right
Water
Water
Pool Cover
Pool Cover
Motor
Motor
Expand Left Reel
Expand Left Reel
Figure 5.
Reel Adjustment for Uneven Cover
Retraction
Page 14
Expand Reel
Expand Reel
Water
Water
Pool Cover
Pool Cover
Motor
Motor
Expand Right Reel
Expand Right Reel
Water
Water
Pool Cover
Pool Cover
Motor
Motor
Expand Right Reel
Expand Right Reel
Cover-Pools
T3 Evo
®
Section 10. Advanced Troubleshooting
and Repair
10.1 Slip Clutch Adjustment
(See checklist at front of manual for your included
features.)
The slip clutch may need to be adjusted if the cover
pauses as it travels across the pool or will not
complete the open or close cycle. Make sure there
is nothing interfering with the cover operation before
adjusting the slip clutch. Water on the cover, low
pool water level, bad track pulleys, and dirt or debris
in the track can all cause the clutch to slip. If the
clutch is slipping due to the reasons above, fix the
problem, don't adjust the slip clutch.
Loosen
Loosen
Figure 6.
Slip Clutch Adjustment
To adjust the slip clutch:
1. Use a 1/2" socket, 6" socket extension and a
ratchet handle. Tighten both bolts equally by
turning nuts clockwise in 1/8 turn increments.
See Figure 6.
2. After both nuts have been adjusted, run the
cover. If the clutch is slipping before the cover
is completely opened or closed, additional
adjustment is needed. If for some reason you
feel the slip clutch is too tight, loosen the nuts
evenly by turning nuts counter-clockwise in 1/8
turn increments and run the cover after each
adjustment.
NOTE: DO NOT OVER TIGHTEN THE CLUTCH TO
THE POINT THAT IT WON'T SLIP IF OVERRUN.
Automatic Pool Cover | Owner's Manual
™
Tighten
Tighten
