Costway TQ10041DE Manual Del Usuario página 11

Coche electrico para ninos
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
REMOTE CONTROL DIAGRAM
low speed
frequency
middle speed
high speed
forward
speed
backwad
Remote control first. When the remote control is on, foot
pedal is not workable
Operation Manual:
Take out the remote control, open the battery compartment on the
back of the remote control and add two AAA LRO3 alkaline
batteries. Pay attention to the polarity of the batteries. When the
alignment light and speed indicator light up, it indicates that the
battery installed is correct. This product does not provide dry
batteries.
<Button Description >
1)Long press on the frequency key (M) 2-4 seconds, low speed
LED light is flashing. Turn on the power of the car, low speed LED
light keep flashing to long lighting, then the frequency binding is
successful. If the frequency binding is failed (low speed LED light
flashing), remove the battery and repeat steps.
P: Press to brake
S: Speed:press to change speed (low, middle and high speed).
△Forward ▽Backward
Turn left
Turn right
2) Brake button: Press it to stop moving; press it again to move.
20
emergency brake
Warning
Only used by adults
trun left
trun right
turn left
turn right
3) Speed selection key and speed indication: used to select speed
of the car. Press the key once to switch the speed once. 3 speeds
are cyclically switched, and the switching sequence is:
low-medium-high. The speed indicator is arranged from top to
bottom on the remote control: high-speed lamp, medium-speed
lamp, low-speed lamp; when switching to one speed, the
corresponding indicator lamp will light up. Note: The speed grade
changes only when moving forward.
4) Forward/backward keys: used for forward and backward
movement control. When one of the keys is pressed, the moving
speed will slowly increase to reach the set speed level. Therefore,
children will not have a sudden impact.
5) Left turn/right turn key: used for left and right direction control.
Note: without operation after 10 seconds, indication light will off
into power saving mode.
CHARGING INSTRUCTIONS
1.Insert the charger jack into the charging hole of the car.
2.Plug the charger plug into the stable matching AC power supply
as shown in the picture.
21
loading