Idiomas disponibles
Idiomas disponibles
Owner's manual
TROUBLESHOOTING
•
Check that the electricity supply has not been shut o .
•
If you cannot turn the hob o after using it, disconnect it from the
power supply.
•
If alphanumeric codes appear on the display when the hob is switched
on, consult the following table for instructions.
DISPLAY CODE
Cookware is detected but it is not
compatible with requested operation.
F0E1
Wrong power cord connection.
F0E7
The control panel switches o because
F0EA
of excessively high temperatures.
The cooking zone turns o when the
F0E9
temperatures are too high.
F0E2, F0E4, F0E6,
Disconnect the hob from the power supply.
F0E8, F0EC, F1E1,
Wait a few seconds then reconnect the hob to the power supply.
F2E1, F6E1, F6E3,
If the problem persists, call the service centre and specify the error code that appears on the display.
F7E5, F7E6
d E
The hob does not switch heat up.
[when the hob is off]
The functions do not come on.
The hob does not allow a special
function to be activated.
e.g.
:
The hob automatically sets a minimum
e.g.
power level to ensure that the cooking
[Power level lower than
zone can be used.
level requested]
SOUNDS PRODUCED DURING OPERATION
Induction hobs may whistle or creak during normal operation.
These noises actually come from the cookware and are linked to the pan
bottoms' characteristics (for example, when the bottoms are made from
di erent layers of material or are irregular).
DESCRIPTION
The cookware is not well positioned on
the cooking zone, or it is not compatible
with one or more cooking zones.
The power supply connection is not
exactly as indicated in "ELECTRICAL
CONNECTION" paragraph.
The internal temperature of electronic
parts is too high.
The internal temperature of electronic
parts is too high.
DEMO MODE on.
The power regulator limits the power
levels in accordance with the maximum
value set for the hob.
The power regulator limits the power
levels in accordance with the maximum
value set for the hob.
Please note: The presence of water, liquid spilled from pots or any objects
resting on any of the hob buttons can accidentally activate or deactivate
the control panel lock function.
POSSIBLE CAUSES
These noises may vary according to the type of cookware used and the
amount of food it contains and not the symptom of something wrong.
SOLUTION
Press On/O
button twice to remove the
F0E1 code and restore the functionality of the
cooking zone. Then, try to use the cookware
with a di erent cooking zone, or use di erent
cookware.
Adjust the power supply connection according
to "ELECTRICAL CONNECTION" paragraph.
Wait for the hob to cool down before using it
again.
Wait until the cooking area has cooled o
before using it again.
Follow the instructions in the "DEMO MODE"
paragraph.
See paragraph "Power management".
See paragraph "Power management".
EN
