Worx Nitro WX842 Serie Manual Original página 12

ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
pack
Charging the battery pack
ASSEMBLY
Installing the belt hook
NOTE: The belt hook can be
installed on the left or right side
of the nail gun.
Loading the tool with brad nails
1. Remove the battery pack if
installed.
2. Squeeze the magazine release
button located on the rear of
the magazine and slide the
magazine cover open
3. Place brad nails in the upper
left corner of channel
4. Push the magazine cover
closed until it securely snaps
into place, you may now reinstall
battery pack
WARNING: Use safety
12
gloves. Keep the tool
pointed away from yourself and
others when loading nails.
Failure to do so could result in
possible serious personal injury.
OPERATION
Single sequential actuation
mode: Provides accurate nail
placement
Contact actuation mode: Allows
for fast repetitive nail placement
WARNING: The nail gun
will not function properly
if the selector is not securely
seated in either position. Always
assure the selector is seated
properly to avoid an unexpected
nail discharge and possible
serious personal injury.
20V Cordless 18 Gauge Brad Nailer
FIGURE
-Push the workpiece contact
See Fig. A1, A2
trigger
See Fig. A3
the workpiece contact.
-Squeeze and hold the trigger.
Push the tool against the
See Fig. B
work surface to depress the
workpiece contact and drive a
nail.
-Release the workpiece contact
once after each nailing action.
-Move the tool and then push the
workpiece contact again.
NOTE: The nail gun will operate
off trigger and pushing the work
piece contact against the work
surface simultaneoulsly
See Fig. C1, C2
NOTE: If there is no nailing
action within 5 seconds after
pushing the workpiece contact,
workpiece contact once and
then operate again.
WARNING: Never wedge or
hold back the workpiece contact
mechanism during operation of
the tool. Doing so could result in
possible serious injury.
Depth of drive adjustment
Turn the depth of drive
adjustment knob up or down to
change the driving depth.
NOTE: Drive a test nail after
each adjustment until the
desired depth is set.
See Fig. D
LED worklight
NOTE: The LED worklights will
be activated when pressing the
workpiece contact.
NOTE: The LED Worklights
provide feedback to indicate
whether the tool is functioning
properly.(See troubleshooting)
See Fig. E1, E2
See Fig. F
See Fig. G
EN