Blaupunkt VIO-D30 Guía Rápida página 10

4.2. Ceiling Installation without mounting bracket
 S tep 1: Find the desired installation place for the camera. Position the camera according to the area you
would like to monitor. Please mind that a power socket is in sufficient proximity. Check the WIFI signal
and ensure that the desired monitoring area is in view by using the "Live View" option.
 Step 2: Use hex wrench in the accessories bag to open dome enclosure by unfastening three inner hex
screws on enclosure.  Step 3: Please take out the mounting map sticker in the accessories bag, and then stick it on the ceiling or
the wall according to your monitor area requirements.
 Step 4: Use the mounting map sticker, to mark the position of the drilling points. There are three holes for
the screws and a big hole for the Ethernet Network port and Camera Power connector.
 Step 5: Drill the three holes for the plastic dowels on the installation surface and then insert the three
plastic dowels in the holes, securing them firmly.
Note:
 If the Ethernet Network port and Camera Power connector need to exit from the back of the camera
through the installation surface, drill a hole according to the size of the bigger hole on the mounting
map sticker.
 If the Ethernet Network port and Camera Power connector need to exit from the side of the camera
the cable must go through the "U-shape side exit" on dome pedestal.

Note:
If due to special circumstances, such as a reinforced concrete wall, it's not possible to drill a hole of
20mm diameter, you have the option to cut off the thick Ethernet Network port - see "Chapter 2. Product
Appearance", and seal it with a proper sealing tape. With this option a 12mm diameter drill is needed.
Alert: If you decide to cut off the Ethernet Port, you will lose the possibility to connect the camera by
Ethernet cable to a router or NVR. Additionally, you lose your right of return.

Step 6
 Adjust the dome camera to the proper position according to the mounting map sticker and then pull cable
through the "U-shape side exit" on Installation surface. Line up the three screw holes in the dome pedestal
to the three plastic dowel holes in the installation position. Fix the three screws in the three plastic dowels
firmly.
 Note: We recommend taking a picture of the label at the back of the camera. In case you need to check
the serial number, MAC address or QR-Code.

Step 7
 Adjust the dome camera lens by moving the camera rotation bracket, and check the position of the
camera with the live image of the camera on your mobile device. The camera rotation bracket can be
moved manually by 355 degrees left to right and 64 degrees up or down. To prevent that the LEDs on the
LED ring get blocked by the metal housing of the dome camera. It is important to rotate the LED ring
horizontally by 355 degrees and adjust the lens image to the desired position.

Step 8
 Use three Inner hex wrench screws to fix the Dome housing on the pedestal.

Step 9
 Connect the Camera Power connector - see "Chapter 2. Product Appearance" - to the included power
supply cable. Then connect the power supply cable to the power line socket. Optional: If you want to install
your camera via Ethernet cable, please connect your camera to the router using an Ethernet cable.
Note:
When it rotates to 64° vertically, please pay attention to the image rotation direction to avoid the
outer cover blocking IR light and influencing IR effect.
8