Blackmagic Design Cintel Manual De Instalación Y Operación página 6

Removing the Reader from the Scanner
Remove the Audio and KeyKode Reader module from the Cintel Scanner before performing
the upgrade.
1
2
1. Power off the Cintel 2. Remove adjustment knob
3. Remove covers 4. Detach reader
1 Make sure power is disconnected from your
Cintel Scanner.
2 On the reader's upper adjustment knob, you'll find a
small retention screw recessed into one side. Use a
2.5mm HEX driver to loosen this screw and slide the
knob off its spindle. This lets you remove the reader's
upper cover.
3 Remove the upper and lower covers from the Audio
and KeyKode Reader by unscrewing the 6 x M3
screws with the T10 driver. The screws are 'captive'
so they remain attached to the reader. Removing the
covers gives you access to the captive screws needed to remove the reader from your
Cintel scanner.
4 Detach the Audio and KeyKode Reader from your scanner using the 3 x captive M3 screws.
Set aside the covers and adjustment knob in a location that will not interfere with your audio
arm sub assembly upgrade.
2
3
3
4
Cintel Audio and Keykode Reader Upgrade
4
6