cecotec CONGA 999 MAP GENESIS Manual De Instrucciones página 32

ENGLISH
Cleaning the drive wheels and the omnidirectional wheel Fig. 11
Use a clean, dry, soft cloth to wipe dust off the drive wheels and the omnidirectional wheel
located on the bottom of the robot vacuum cleaner.
Charging base. Fig. 12
Use a clean, dry, soft cloth to wipe dust off the infrared lens and charging terminals. It is
recommended to clean them once a month.
Charging and replacing the battery. Fig. 13
- To lengthen the battery shelf life, leave the robot vacuum cleaner to charge in the charging
base when not in use.
- Remove the battery and store it in a safe, dry place if the robot vacuum cleaner will not be
used for a long period of time.
To replace the battery, follow the instructions below
1. Unscrew the battery compartment screws and remove the battery-compartment cover
and the battery.
2. Insert the new battery with the battery label facing up.
Put the battery and the battery-compartment cover back in place and properly fix the
3.
screws again.
6. TROUBLESHOOTING
Beeps Error Solution
1 Low battery Place the robot in the charging base.
Bumper error Carefully clean the sensors with a clean, dry cloth.
Restart the robot vacuum cleaner. To do this, switch the
robot off and on.
2 Fall-detection Carefully clean the sensors with a clean, dry cloth.
sensor error Restart the robot vacuum cleaner. To do this, switch the
robot off and on.
4 Driving-wheel Check if the drive wheel is blocked.
fault
0 Charging error Check if the charging base indicators are on. Otherwise,
contact the official Technical Support Service of Cecotec.
Clean the charging terminals with a clean, dry cloth.
Check if the robot vacuum cleaner beeps when it gets to the
charging base. Contact the official Technical Support Service
of Cecotec.
62
CONGA 999 MAP GENESIS
7. TECHNICAL SPECIFICATIONS
Product: Conga 999 Map Genesis
Product reference: 08065
Input: 19V 0.6 A
Battery: 14.4 V Li-ion 2000mAh
Frequency bands: 2.4 GHz + Bluetooth
Maximum Transmission Power: 17.5 dBm
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
8. DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES
This symbol indicates that, according to the applicable regulations, the
appliance and/or batteries must be disposed of separately from household
waste. When this product reaches the end of its lifetime, you should dispose
of the batteries/accumulators and take them to a collection point designated
by the local authorities.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old electrical and electronic appliances
and/or their batteries.
Compliance with the above guidelines will help protecting the environment.
9. TECHNICAL SUPPORT AND WARRANTY
Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the
time of delivery of the product under the terms, conditions, and deadlines established by the
applicable regulations.
It is recommended that repairs be carried out by qualified personnel.
If at any moment you detect any problem with your product or have any doubt, do not hesitate
to contact the official Cecotec Technical Support Service at +34 96 321 07 28.
10. COPYRIGHT
The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES,
S.L. All rights reserved. The contents of this publication may not, in whole or in part, be
reproduced, stored in a retrieval system, transmitted, or distributed by any means (electronic,
ENGLISH
63
CONGA 999 MAP GENESIS