Idiomas disponibles
Idiomas disponibles
EN
9.8
ADJUST THE CUTTING
DIAMETER
The machine is set at a 14" (356 mm) cutting diameter. You
can adjust to a 16" (406 mm) cutting diameter.
Set the cutting diameter to 14" (356 mm) for greater
runtime and 16" (406 mm) for a larger cutting area.
1. Remove the battery pack.
2. Remove the blade screws from the cut-off blade (1).
3. Turn the cut-off blade 180°.
4. Tighten the blade screws.
180
9.9
LINE CUT-OFF BLADE
This trimmer is equipped with a line cut-off blade (1) on the
guard. The line cut off blade continuously trims the line to
ensure a consistent and efficient cut diameter. Advance line
whenever you hear the motor running faster than normal, or
when trimming efficiency diminishes. This will maintain best
performance and keep line long enough to advance properly.
10
MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
NOTE
1
IMPORTANT
IMPORTANT
IMPORTANT
English
10.1
GENERAL INFORMATION
Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
•
Store the machine in cool and dry place.
•
Use correct clothing, protective gloves and safety glasses.
10.2
CLEAN THE MACHINE
•
Clean the machine after use with a moist cloth dipped in
neutral detergent.
•
Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or excessive
grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
•
Do not spray water onto the motor and electrical
components.
10.3
REMOVE EXCESS LINE
1. Push the tabs (2) on the sides of the trimmer head at the
same time.
2. Pull and remove the spool cover (1).
10
IMPORTANT
