TAD C700 Manual De Instrucciones página 11

Preamplificador
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 68
Main unit rear panel
Power unit
DC2
DC OUTPUT
DC1
A C IN
1
2   
1 AC IN connector
Attach the accessory power cord here.
2 DC OUTPUT connectors (DC1/DC2)
Use the accessory DC cord to connect the power unit to
the main unit.
3 ANALOG OUTPUT connectors (R/L)
Depending on the type of connectors on your power
amplifier, you can select either balanced (XLR-3-32) or
unbalanced (RCA pin jack) connectors.
4 REC OUT connectors (LINE 3/LINE 6)
Connect to an analog recording device. Set the INPUT
SELECTOR to switch between outputs.
When LINE 3 input is selected, no signal will be output
from LINE 3.
When LINE 6 input is selected, no signal will be output
from LINE 6.
5 DC INPUT connectors (DC1/DC2)
Use the accessory DC cord to connect the main unit to
the power unit.
Main unit
Balanced output connectors
(equivalent to XLR-3-32)
1 : Ground
3
1
2
3
2 : Hot
3
3 : Cold
Balanced input connectors
(equivalent to XLR-3-31)
1 : Ground
2
1
2 : Hot
3
3 : Cold
4
5
4
5
6
7
8
6
7
7
8
6 ANALOG INPUT connectors (R/L)
In accordance with the type of connector on the device
used, you may select either balanced (XLR-3-31) or
unbalanced (RCA pin jack).
7 SLAVE IN jack
For details, see page 17 "Linking multiple Pre-Amplifiers".
8 SIGNAL GND connector
Use wire material to connect the signal grounds for
multiple components. This is effective for eliminating
differences in polarity between multiple components and
thus providing for greater stability in operation.
Do not connect a safety ground wire to this
connector.
9 MASTER OUT jack
For details, see page 17 "Linking multiple Pre-Amplifiers".
3
3
4
4
9
9
6
6
TAD-C700
11
loading