Idiomas disponibles
Idiomas disponibles
8.
On 46" Decks: Looking at the cutting deck from the left
side of the tractor, locate the deck support pin on the rear
left side of the deck. Pull the deck support pin outward to
release the deck from the deck lift arm. See Figure 7-4.
9.
Carefully remove the PTOcable from the rear of the
cutting deck by removing the hair pin clip which secures it.
Remove the spring from the deck idler bracket. See Figure
7-6.
Deck Lift Arm
Deck Support
Pin
9.
7.
8.
Figure 7-4
Repeat the above steps on the tractor's
right side.
On all decks:
Move the deck lift lever into the top notch
on the right fender to raise the deck lift arms up and out of
the way.
On 38" Decks: Gently slide the cutting
deck toward
the
front of the tractor
carefully
guiding
the hooks on the deck
off of the deck stabilizer
rod.
On 42" & 46" Decks: Remove the bow-tie
cotter pin
securing
the deck stabilizer
rod to the deck. Slide the deck
lift rod from the mounting
weldment
on the deck as seen
in Figure 7-5.
.................
...............
_<_ .................
..................................
Figure
7-6
10.
Gently slide the cutting
deck (from the leftside)
out from
underneath
the tractor.
Tires
i_i
WARNING!
Never exceed the maximum
inflation
pressure shown on the sidewall
of tire.
The recommended
operating
tire pressure is:
Approximately
10 psi for the rear tires
Approximately
14 psi for the front tires
IMPORTANT:
Refer to the tire sidewall for exact tire
manufacturer's
recommended
or maximum
psi. Do not
overinflate.
Uneven tire pressure could cause the cutting
deck to
mow unevenly.
Battery
CALIFORNIA PROPOSITION 65 WARNING!
Battery posts, terminals,
and related accessories
contain
lead and lead compounds,
chemicals
known
to the State of California
to cause cancer and
reproductive
harm. Wash hands after handling.
CAUTION:
If removing
the battery, disconnect
the
NEGATIVE (Black) wire from it's terminal
first,
followed
by the POSITIVE (Red) wire. When re-
installing
the battery,
always connect
the POSITIVE
(Red) wire its terminal
first, followed
by the
NEGATIVE (Black) wire.
Figure 7-5
SECTION 7
--
SERVICE
25
