ENGLISH
3. ASSEMBLY
Installation of the mounting bracket
Fig. 2 key:
A
Concrete ceiling
B
Wooden ceiling
1.
Drill a ø8 mm hole in the ceiling and insert the bolt. Align the mounting bracket with the
hole and tighten it with the nut.
Remove the clevis pin and clevis from the downrod. Fig. 3
2.
3.
Slide the downrod through the canopy and the coupling cover. Fig. 4
Pass the fan wires and the earth wire through the downrod. Fig. 5
4.
Loosen the screws of the downrod bracket and then place the downrod in its bracket.
5.
Align the holes in the clevis pin of the downrod with the holes in the bracket. Make sure to
insert the straight part of the clevis pin through the hole in the end of the clevis pin and
press until the crimped part snaps into position. Fig. 6.
6.
Finally, retighten the screws. Fig. 7
WARNING
It is very important that the downrod bracket clevis pin is correctly installed and that the
screws are tightened securely. If the pin, clevis, or screws are not correctly positioned, the fan
may fall down.
Installing the blades
7.
Place the blade bracket. Remove the corresponding screws from the assembly kit and
screw them. Fig. 8
Place the blades on the motor assembly. Fig. 9
8.
9.
Remove the screws from the motor assembly. Place the lamp bracket on the motor
assembly. Next, tighten the screws. Fig. 10
Hanging the fan
10. Lift the fan carefully and install the downrod and hanging ball into the mounting bracket
attached to the ceiling. Make sure that the groove in the hanging ball is properly aligned
with the tab on the mounting bracket. Fig. 11
Fig. 11 key:
1. Slot
2. Clip
3. Mounting bracket
Warning: the fan must be placed at a minimum distance of 230 cm from the floor.
44
ENERGYSILENCE AERO 10000 PRO