Idiomas disponibles
Idiomas disponibles
2. BEFORE USE
-
This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
-
Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
-
Fan
-
Remote control
-
Instruction manual
3. ASSEMBLY
Assembling the fan. Fig. 4
1.
First, remove the cap (by turning it clockwise) and the plastic nut (by turning it
counterclockwise). Secure the rear grille so that it is perfectly aligned with the motor; then,
tighten the plastic nut clockwise.
2. Insert the blades into the shaft and make sure that the shaft pin fits into the slot in the
blades. Turn the cap counterclockwise to tighten the blades.
3. Secure the front and rear grilles to each other using the clip.
Assembling the base and tube. Fig. 5
1.
Unscrew the bolt from the tube.
2. Insert the tube into the base and tighten the bolt.
3. Loosen the height adjustment knob. Next, place the inner tube at the desired height.
NOTE: if you cannot find the inner tube, it may be due to the fact that it is stuck in the tube.
You will have to pull it out.
4. To fasten the fan body to the tube, slightly loosen the adjusting nut located at the bottom
of the fan. Afterwards, place the fan in the tube and tighten the adjusting nut again.
WARNING: the height adjustment knob must be securely fastened before fitting the fan body.
ENERGYSILENCE 620 FLOW CONTROL
ENGLISH
25
