Fitting & Operation Information:
Please refer to the instruction diagrams (P. 51 - 64):
Chassis
Front wheel
Rear wheel
Brake
Front wheel swivel
lock
Rear Suspension
Basket
Chassis
Carrycot
Carrycot hood
Carrycot
Carrycot apron
Carrycot mosquito
net
1-
Opening:
Release the autolock (a) and lift the handle upwards until the chassis locks into
position (b).
Check the chassis has locked in place.
2-
Adjusting handle position:
3-
Fitting:
4-
Removing:
5-
Fitting:
6-
Removing:
7-
Applying:
8-
Releasing:
9-
Applying:
10-
Releasing:
11-
Firm:
12-
Soft:
13-
Accessing rear compartment:
14-
Closing:
NOTE: The chassis cannot be closed in pram mode or car seat mode.
While pulling both secondary levers (a) back, Press down on the handle (b) until
the autolock retains the chassis in the folded position (c).
Adjust the handle to the lowest position (See Step 2) for the most compact fold.
15-
Preparation:
Remove mattress and liner from carrycot (a).
Unfold both frame bars until they locked into positions (b).
16-
Refit the liner into the carrycot (a) and secure the zip fasteners (b).
Refit the mattress over the liner in the carrycot (c).
There are a set of "D" rings located at the base of the carrycot for the attachment
of a separate safety harness approved to BS EN 13210 should this be required
(harness not supplied). Push the "D" rings through the slots in the liner (d).
17-
Using the ventilation flap:
18-
Opening:
19-
Closing:
20-
Using the hood sun visor:
21-
Opening the hood viewing window:
22-
Closing the hood viewing window:
23-
Note: The carrycot can only be fitted rearward facing as shown in illustration.
24-
Fitting:
Dots are marked on the chassis mounts and carrycot mounts (a). These should be
on the same side and aligned if fitted correctly.
25-
Removing:
Open the carrycot hood (See Step 18) .
Press the release button under the hood frame (a).
Lift the carrycot off the chassis (b).
26-
Fitting:
Removing is a reversal of this procedure.
27-
Access/storage:
28-
Fitting:
Removing is a reversal of this procedure.
4