BGS technic 8381 Manual De Instrucciones página 8

Juego de pistola de pintura se aire
Ocultar thumbs Ver también para 8381:
Idiomas disponibles

Idiomas disponibles

AIR SOURCE
1. This tool works with clean, dry compressed air at a regulated pressure of 3 to 5 bar. Too low or
too high pressure as well as moisture and other impurities in the compressed air damage the tool
and affect the quality of the paintwork.
2. The compressed air source must be able to provide the required air volume (l/min) without strong
fluctuations.
3. Drain the compressed air system before each use. Water in the compressed air line gives a bad
result.
4. Clean or replace the air filter on the compressor at the specified intervals.
5. Operate the pneumatic tool with the pressure specified in the "Technical data" chapter.
UNPACKING
When unpacking, make sure that all parts are present.
Contact your dealer if parts are missing or damaged.
SAFETY WHILE OPERATING
Take enough time for a careful selection of a working area. Take care that your workplace is near to
the compressor and blasting material. Attention! Always stay aware. Remove the device or other
objects from the working area. Persons and animals must not remain in the working area. Never
direct the air tool against persons or animals. Always wear safety equipment like safety glasses and
dust masks when working with this air tool (see chapter "Occupational Safety").
COMPONENTS
1
Plastic cup
2
Lid
3
Threaded ring
4
Mouthpiece
5
Trigger
6
Air flow regulator
7
Hook for hanging
8
Spray regulator
9
Colour regulator
10 Handle
11 Air connection
TECHNICAL DATA
Working pressure: 3 - 5 bar (44 - 73 psi)
Max. pressure: 6.2 (90 psi)
Air inlet: 1/4"
PREPARATION
1. Mask off components that will not be painted and cover surrounding tools, vehicles, etc. with foils.
Otherwise, the paint mist during painting will settle on it.
2. Check and replace damaged or worn parts on the tool.
3. Make sure the trigger and nozzle are working properly.
4. Check that the air hose is securely connected to the paint spray gun.
5. Set the pressure of the compressed air system to 3 to 5 bar.
6. Connect the paint spray gun to the compressed air system.
7. The pressure required depends on the viscosity and characteristics of the paint.
8. Fill the desired colour into the cup and close it with the lid.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Sound pressure level (LpA): 75 dB(A)
Sound power level (LwA): 86 dB(A)
Air consumption (125 ml spray gun): 85 L/min.
Air consumption (600 ml spray gun): 170 L/min
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
loading