Idiomas disponibles
Idiomas disponibles
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To reduce the risk of injury, do not attempt to use this
product until you have read thoroughly and understand
completely this operator's manual and the operator's
manual for any power tools used.
TOOLS NEEDED (NOT INCLUDED)
For mounting onto wall studs or concrete:
Drill, Hammer, Level, Pencil, Phillips Screwdriver, Concrete
Anchors (if mounting onto concrete)
MOUNTING THE CABINET ONTO LINK WALL
RAIL
See Figure 4.
WARNING:
Only install screws into sound structural supports (such
as studs and concrete) in areas where no electrical wires,
utility cables, pipes, or other obstructions are located.
Failure to follow these instructions can result in death,
electrical shock, or other serious personal injury.
ASSEMBLY
ASSEMBLING THE INTERIOR SHELF
See Figures 2 - 3.
This cabinet comes pre-assembled except for the interior
shelf.
„ This unit has six pre-determined shelving height positions.
Select your preferred height position.
„ Insert the shelf clips (4) into the slots in the interior cab-
inet. Make sure the shelf clips are all on the same level.
„ Insert the interior shelf into the cabinet by tilting the shelf
diagonally and placing onto the shelf clips.
„ If mounting onto a wall rail, insert the bumpers (2) into
the round holes on the bottom back panel of the cabinet.
INSTALLATION
WARNING:
Do not lift the product without help. Hold it close to your
body. Keep your knees bent and lift with your legs, not
your back. Ignoring these precautions can result in back
injury.
„ Mount the wall rail as described in the rail's Operator's
Manual.
„ Insert bumpers (2) into holes on the bottom back panel
of the cabinet if not already installed.
„ With the help of at least one other person, carefully lift the
cabinet and position the cabinet onto four of the raised
octagonal patterns on the wall rail.
NOTE: Cabinet cannot be installed over two parallel rails.
„ IMPORTANT! To ensure the cabinet is seated properly,
check that the holes through the back wall of the
cabinet are lined up with the corresponding holes in
the LINK wall rail.
NOTE: If extra support is needed, insert #10 screws into
the holes at the back of the cabinet into the screw holes
in the wall rail.
To unmount the cabinet:
„ Remove all of the items stored in the cabinet.
NOTE: Remove the #10 screws (if installed) from the
cabinet.
„ With the help of at least one other person, carefully lift
the cabinet away from the wall rail.
4 — English
