Idiomas disponibles
Idiomas disponibles
An appliance socket with earthing contact is inte-
grated in the machine. An external power tool can be
connected there.
In position
the machine can be switched on
and off by the power tool connected. Dirt is picked
up from the source of dust immediately. To comply
with regulations, only approved dust producing tools
should be connected.
The maximum power consumption of the connected
electrical appliance is stated in section "Specifica-
tions".
Before turning the switch to position
that the tool connected to the appliance socket is
switched off.
3.3
Push&Clean
The machine is equipped with a semi automatic filter
cleaning system, Push&Clean. The filter cleaning
system must be actuated latest when the suction
performance is no longer sufficient. Regular use of
the filter cleaning feature maintains suction perfor-
mance and increases the lifetime of the filter. For
instruction see quick reference guide.
3.4
Antistatic connection
CAUTION
The machine is equipped with an antistatic
system to discharge any static electricity that
may develop during dust pick-up.
The antistatic system creates an earth ground con-
nection to the inlet fitting of the container. For proper
function the use of an electrical conductive or anti-
static suction hose is recommended.
3.5
Wet pick-up
CAUTION
The machine is equipped with a float sys-
tem that shuts off the airflow through the
machine when the maximum liquid level is
reached. You will hear a noticeable change
of the sound from the motor and notice that
the suction power decreases. When this oc-
curs, switch the machine off. Disconnect the
machine from the socket. Never pick up liquid
without the float body in place.
•
If foam appears, stop work immediately
and emty the tank.
•
Clean the water level limiting device regu-
larly and examine it for signs of damage.
Before emptying the container, unplug the machine.
Disconnect the hose from the inlet by pulling out the
hose. Release the latch by pulling them outwards
so that the motor top is released. Lift up the motor
top from container. Always empty and clean the con-
tainer.
6
OEL=Occupational Exposure Limit,
1)
ensure
*)
Empty by tilting the container backwards or sideways
and pour the liquids into a floor drain or similar.
Put back the motor top to the container. Secure the
motor top with the latches.
3.6
Dry pick-up
CAUTION
Picking up environmentally hazardous
materials.
Materials picked up can present a hazard to
the environment.
•
Dispose of the dirt in accordance with le-
gal regulations.
3.7
Emptying after dry pick-up
Remove the electrical plug from the socket before
emptying after dry pick-up. Check the filters and
dustbag regularly. Release the latch by pulling them
outwards so that the motor top is released. Open up
the motor top from container.
Cartridge filter: To clean the filter you can either
shake, brush or wash it. Wait until it is dry before you
reuse it.
Dustbag: check bag to ensure the fill factor. Replace
dust bag if necessary. Remove the old bag. The new
bag is fitted by passing the carboard piece with the
rubber membrane through the vacuum inlet. Make
sure that the rubber membrane is passing past the
heightening at the vacuum inlet.
After emptying: Close motor top to the container and
secure the motor top with the latches. Never pick up
dry material without cartridge filter and dustbag fitted
in the machine. The suction efficiency of the vacuum
cleaner depends on the size and quality of the filter
and dust bag. Therefore - use only Original filter and
dust bags.
4
After using the machine
4.1
After use
Remove the plug from the socket when machine is
not in use. Wind up the cord starting from the ma-
chine.
4.2
Transport
•
Before transporting the machine, close all the
latches.
•
Do not tilt the machine if there are liquids in the
dirt tank.
•
Do not use a crane hook to lift the machine.
4.3
Storage
CAUTION
Store the appliance in a dry place, protected
from rain and frost. The machine shall be
stored indoors only. Wet filters and the interior
part of the liquid container shall be dried be-
fore storage.
Optional accessories / Option depending on model
*)
Original instruction
