During Operation - AERMEC FCX P 17 Manual De Instrucciones E Instalación

EN
and safety. Our units are designed
to be integrated with Aermec
additional heating accessories
and if properly fitted they have no
effect on the surrounding envi-
ronment, the technical spaces are
unchanged with respect to the
basic unit.
Before installation, check the
technical spaces required:
• for installation;
• for connection to the hydraulic
circuits and to any valve;
• for connection to the power
supply;
• for connection of an external pan-
el flush to the unit (when provided
for);
• for the setup of the flow and in-
take ducts (for models requiring it);
• for correct and sufficient both
intake and supply air flow,
• for draining condensation;
• for cleaning the filters;
• for cleaning internal components
and for maintenance.
WARNINGS ON USE
ATTENTION: The appliance can
be used by children over the age
of 8 and by people with reduced
physical, sensory or mental capa-
bilities or without experience or
necessary knowledge, as long as
they are supervised or have been
instructed on the safe use. Of
the appliance and on the under-
standing of the dangers inherent
to it. Children must not play with
the appliance. The cleaning and
maintenance to be carried out by
the user must not be carried out
by children without supervision.
DO NOT USE THE FAN COIL
IMPROPERLY
The fan coil must not be used to
breed, deliver and raise animals.
AIR OUT THE ROOM
Periodically air out the room in
which the fan coil has been in-
stalled; this is particularly impor-
tant if the room is occupied by
many people, or if there are gas
appliances or sources of odours.
22
ADJUST THE TEMPERATURE
CORRECTLY
Ambient temperature should
be regulated to ensure maxi-
mum comfort, particularly for
the elderly, infants and invalids.
Prevent temperature fluctuations
between indoors and outdoors
greater than 7°C during summer.
Excessively low temperatures
during summer involve higher
electrical consumption.
DIRECT THE AIR FLOW COR-
RECTLY
Air delivered by the fan coil must
not be directed onto people. Even
if the air temperature is higher
than the ambient temperature, it
can cause a cold sensation and,
therefore, discomfort.

DURING OPERATION

During operation, always leave
the filter mounted on the fan coil;
otherwise the dust in the air will
dirty the coil surface.
IT IS NORMAL
When in cooling mode, water
vapour can come out of the fan
coil air flow.
When in heating mode, a slight
hissing sound can be heard near
the fan coil. The fan coil may
sometimes emit unpleasant
odours due to the accumulation
of substances present in the en-
vironment (clean the filter more
often, especially if the room is not
aired out regularly).
During operation, noise and/or
a creaking sound may be heard
from inside the device, due to the
heat expansion of the elements
(plastic and metal). However, this
does not mean there is a mal-
function and it does not damage
the unit as long as the inlet water
temperature remains within the
operating limits.
OPERATION ANOMALIES
In the event of operation anoma-
lies, power off the unit and then
power it back on and re-start the
unit.
FCX P-PE-PO-PV
Do not try to repair the unit on
your own, as it may be very dan-
gerous!
If the problem persists, call the
Area After-sales Service immedi-
ately.
DO NOT PULL THE ELECTRIC
CABLE
It is very dangerous to pull, step
on or crush the power supply
cable or secure it using nails or
staples.
The damaged cable can cause
short circuits and injury to per-
sons.
ELECTRIC POWER SUPPLY
CABLE
If the power supply cable is
damaged, it must be replaced
with a new cable of adequate
section. Have the repair made by
"Qualified personnel", in order to
prevent any risk.
Do not repair damaged cables.
For the electric power supply,
use integral cables with suitable
section for the load.
DO NOT INTRODUCE OB-
JECTS INTO AIR VENTS
Do not introduce any objects into
the air outlet slots.
This could cause injury to persons
or damage the fan.
IFCXPLJ 1412 - 6456063_01