Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
APPLICATIONS
Wood and aluminum sash.
PREPARATION BEFORE OPERATION
Make the following preparations before operating the power tool:
1. Installation
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 5/16" (8 mm) diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 2" (50 mm) plus the thickness of the work bench.
For example, use 5/16" (8 mm) × 3" (75 mm) for a 1" (25 mm) thick work bench.
2. Releasing the locking pin
When the power tool is prepared for shipping, its main parts are secured by a locking pin.
Move the handle (see Fig. 1) slightly so that the locking pin can be disengaged and adjusted as
indicated
in Fig. 5-b.
NOTE:
Lowering the handle (see Fig. 1) slightly will enable you to disengage the locking pin more
easily and safely.
The lock position of the locking pin is for carrying and storage only.
3. Installing the dust bag, holder, stopper and vises.
(The dust bag, holder, stopper and vise assembly are standard accessories).
Attach the dust bag, holder, stopper and vise assembly, as indicated in Fig. 1.
10
3/8" (10 mm)
4 Holes
20-15/32" (520 mm)
Locking Pin
Fig. 5-a
5/16" (8 mm) Bolt
Base
Work Bench
5/16" (8 mm) Nut
Fig. 4
During transport, fit the pin into the
deep slot.
NOTE: This position is not be used
During operation fit
the pin stoppers into
the shallow slot.
Fig. 5-b
for any cutting operation.
Locking Pin
Clockwise
Pull out to disengage.
Rotate the knob 1/4 turn and fit the
pin stoppers into the shallow slot.
Tabla de contenido
