John Bean B 300 Manual Del Operador página 92

92
Trouble shooting
Option 2
Cancel selection of code C just set and return directly
to the operating mode:
— Press the STOP key twice consecutively.
Note: Code C4, for compensation of the clamping
device, cannot be transferred to the
permanent memory.
Below are the change codes available and the relative
selections possible.
Code C0
Setting operating modes preset by the factory:
• Select Code C0
• Select one of the following options:
0* = No action
1 = Set the default values
(state 1 appears briefl y)
Note: The selection is permanently acquired.
Code C3
Selection of unbalance indication, in grammes or
ounces, active when the machine is switched on
0* = Readings in grammes
1 = Readings in ounces
The selected operating mode can be acquired in the
permanent memory.
Code C4
Compensation of residual unbalance, if any, in the
clamping device.
High precision measurement.
Every time the clamping device is replaced,
compensation must be deleted or carried out again
with the new device fi tted.
Resetting the operating status to 0 cancels the
clamping device compensation.
The compensation is also cancelled following:
- balancer calibration or recalibration,
- unbalance optimisation,
- balancer switch off.
• Select Code C4
• Select one of the following options:
0 = Carry out compensation
1 = Compensation completed
0 = Switch off compensation again after the
measuring run
*
= Factory confi guration
...