Tabla De Contenido; Table Of Contents - Dremel 3D40 Traducción De Las Instrucciones Originales

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 89
p. Do not move or bump Dremel 3D40 or the
extruder during operation. The object may build
incorrectly.
q. Do not change colour of filament or spool
during building. Doing so will cancel the object
and may damage the extruder.
r.
Do not pull the filament out until instructed
by the touch screen. Doing so may damage the
extruder.
s. Use extra care not to damage the extruder tip
when clearing debris. Dremel 3D40 will not work
properly with damaged extruder tip and will require
replacement.
t.
Before every build make sure that the build
platform is covered with Dremel specified build
tape. Use of improper build tape may result in
equipment damage and poor object build quality.
u. Be aware of your body position when using
hand tools to remove objects from the build
platform. Sudden tool slip and improper body
position during object removal from the build
platform may result in personal injury.
v. Avoid scratching the build platform when
removing objects. Scratches in the build platform
will result in improper object creation.
w. Do not drop the build platform. Tempered glass
plate may break and result in personal injury.
x. Do not remove tempered glass plate from
plastic holder. Contact with tempered glass plate
edge may result in personal injury.
y. Do not twist or bend the build platform while
removing objects. Tempered glass plate may
separate from plastic holder and result in personal
injury.
z. Dremel is not responsible for structural integrity
or utility of objects created using Dremel
3D40. Structural models created by inexperienced
designers may result in property damage and
personal injury.
SERVICE
a. Always unplug Dremel 3D40 from its power
before performing any service procedures.
Failure to do so may result in personal injury and
equipment damage.
b. Have your Dremel 3D40 serviced only by an
authorized Dremel service centre using only
Dremel replacement parts. This will ensure that
proper operation and safety of Dremel 3D40 is
maintained.
c. Use only Dremel approved materials and
components. Use of object materials, or 3D
objects other than Dremel
materials and genuine Dremel
void warranty.
approved object
®
components may
®
3

TABLE OF CONTENTS

General safety warnings ......................................2
Table of contents...................................................3
Used symbols ........................................................4
3D40 Resources ....................................................5
Glossary of Terms .................................................6
Getting to know your 3D40 ..................................7
Introduction ............................................................9
Kit Contents*..........................................................9
Touch Screen ....................................................... 11
Touch Screen Icons ............................................16
Initial Setup ..........................................................17
Print Studio Software Overview ........................18
Getting Ready to Build .......................................19
Building ................................................................23
Removing Your Object ........................................26
Best Practices .....................................................27
Maintenance .........................................................27
Maintenance and Service ...................................29
®
Consumer Limited Warranty................30
Tabla de contenido
loading

Tabla de contenido