S&P CB-2005 Manual De Instalación. Instrucciones De Uso página 12

• Do not clean the product while it is working and do not immerse it in
water.
• Do not handle the heater with wet hands.
• If the cable gets damaged it must be replaced by S&P – take the
equipment to our official S&P dealer because the work must be done
by specialist personnel to avoid any risk of damage.
• The heater must always work vertically and the air outlet grille should
be located at the bottom.
• In any case you have to respect the national installation standard and
safety requirements valid in your State.
• Only for internal use.
INSTALLATION
• For the version fitted with a towel rail, BEFORE MOUNTING THE FAN HEATER
ON THE WALL:
- Fit the towel rail into the holes underneath the product, figure 2.
- Insert and tighten the 4 (short) screws contained in the bag, figure 3.
- The mimimum distance from the floor reported in figure 4 (30 cm) changes to
60 cm.
• Mount the heater on the wall making sure to observe the minimum distances
from the ceiling, floor and other walls, as shown in figure 4.
• Drill three 6 mm diameter holes in the wall, as shown in figure 5.
• Insert the three wall plugs supplied with the product.
• Insert the 2 upper screws, contained in the same bag, taking care to leave a
distance of 8 mm between the head of the screws and the wall.
• Gripping the heater firmly, hook it onto the two screws; CAUTION! Before releas-
ing the heater make sure it is attached to the 2 screws.
• Then secure the product with the lower screw, figure 6.
USING THE FAN HEATER
The heater is fitted with the controls shown in figure 7.
Model with thermostat
• Starting from the anti-freeze position " ", turn the thermostat knob clockwise
12