Idiomas disponibles
Idiomas disponibles
Translation of original operating instructions
It is absolutely forbidden to touch with the hands into the openings of the pump, if the device is
connected to the power supply.
1． Please inspect the pump visually prior to each use. This applies in particular to the mains connection line and
the mains plug. Make sure that all screws are firmly tightened, and verify the perfect condition of all connec-
tions. A damaged pump must not be used. In any case of damage, the pump has to be inspected by qualified
service staff.
2． Each time the pump is put into operation, please make sure that the pump is set up securely and firmly
standing.
3． To put the unit into operation, please plug the mains plugs into a 230V AC socket. If the water level has
reached or exceeded the cut-in level, the pump will start to run immediately.
4． To stop the operation of the pump, please pull the mains plug off the socket.
5． The electrical pumps of the T.I.P. chlor comfort series are equipped with an integrated thermal motor protec-
tion feature. In the case of overload, the motor will switch off independently and on again after cooling down.
For possible causes and their elimination, please refer to the "Troubleshooting / tips" section 10.
8.1.
Please note for the first operation
All inlet and outlet valves must be open when starting the system. Otherwise this can cause se-
vere damage of the pump.
High suction lift or long suction hoses require additional time and reduce the performance of the
pump. If the pump does not prime, repeat steps.
Note:
Cleaning the pump and filter regularly increases the service life and improves their effectiveness.
If the water level to be dropped in the sand filter tank, you should fill up the tank again before recommissioning.
1. Remove the translucent lid and fill the filter tank with water.
2. Replace the lid ensuring the o-ring is correctly located and start the pump.
After you have done this allow a few minutes (maximum) running for the pump to start delivering water.
9. Maintenance and care
Prior to carrying out any maintenance work, the pump must be separated from the electrical
mains. If you fail to separate the unit from mains, there is a risk of an inadvertent start of the
pump.
We decline any liability for damage caused by inappropriate repair attempts. Any damage
caused by inappropriate repair attempts will avoid all warranty claims.
Cleaning the reusable filter balls:
Open the filter container
-
Remove the filter balls from the filter container and clean it well.
-
Wash out the filter material
-
Wash delicates in the washing machine at 30 °C or rinse well by hand
-
Put the clean filter balls back into the filter container and close it
-
If the filter balls are too worn, they must be replaced with the filter balls from the company T.I.P
-
Observing the conditions of use and the ranges of application of the present device will reduce the risk of possible
operational malfunction and contribute to extend the lifetime of your unit. Sand and other abrasive matters con-
tained in the liquid discharged will speed up the process of wearing and tearing and accelerate the drop in per-
formance.
The user must ensure that maintenance is done from qualified persons, who have carefully read all instructions
for installation and maintenance.
If the device is not used for a long time, the pump and the filter container should be emptied using the devices
provided for this. In the event of frost, water remaining in the pump and filter can cause considerable damage if it
freezes. Store the pump at a dry and frost-proof location. If the pump is operated again after a longer break,
please ensure all sealing and und O-Rings are in good condition. Replace any defect or damaged sealing's.
A regular check of the mechanical and electric parts is recommended:
1. The accurate and right connection of adapters, hose and pipes and secured tightness of all screws.
2. The correct condition of all electric connections and power cords.
3. The vibration of the pump. In case of an excess high vibration, stop the pump immediately and contact your
service partner or the manufacturer.
6
