Altrad Belle HPP Manual Del Operador página 28

CAUTION
CAUTION
Image 1
Tool Tray Installation - Bulldog
1. Remove left-hand side guard and 4 x M8 bolts, nuts & washers (See Image 1)
2. Replace with new side guard and 4 x M8 bolts, nuts & washers provided in the kit. Tighten to
28Nm.
3. Screw 2 x anti-vibration mounts using 2 x M10 washers and nuts provided through location
holes in the new side guard, hand tightened (See Image 2)
4. Hook the tool tray ange underneath the installed side guard and retract both plungers
(See Image 3)
5. Pivot the tool tray upwards until both plungers are located above the slots in the top of
the installed side guard. Release the plunger handles to lock the assembly in place.
(See Image 4)
6. Ensure plungers are fully extended in the side guard slots and all bolts / nuts are correctly
tightened before storing equipment in the tool tray.
Tool Tray Removal - Bulldog
1. Ensuring there is no equipment still stored in the tool tray, retract both plungers and tilt backwards and down to un-hook the ange
from the underside of the side guard.
Tool Tray Installation - HPP Range
1. Line up the 3 x holes on the side of the tool tray with the 3 x holes on the left-hand side
guard. Secure the tool tray to the frame using the 3 x M8 bolts, nuts & washers provided in
the kit. Tighten to 28Nm (See Image 5)
Tool Tray Removal - HPP Range
1. Ensuring there is no equipment still stored in the tool tray, remove the 3 x M8 bolts, nuts &
washers.
Options - Tool Tray
DO NOT lift the Power Pack with the Breaker and/or Breaker Steel still stored in the Tool Tray.
DO NOT leave the Breaker Steel tted inside the Breaker whilst stored in the Tool Tray
Image 2
28
Image 3
Image 4
Image 5