Idiomas disponibles
Idiomas disponibles
In dry mode, the fan runs at low speed by default and the wind speed cannot be adjusted.
The temperature cannot be adjusted.
Note: The exhaust pipe should be removed in dry mode as this may affect performance and the "FL"
water level alarm light will illuminate.
TIMER MODE
•
In standby mode, press the timer button to set the switch-on time. Press the up and down buttons
to set between 0 and 24 hours and the timer indicator lights up.
•
After the air conditioner is switched on, press the timer button to set the switch-off time. Press the
up and down buttons to set between 0 and 24 hours and the timer indicator lights up.
CLEAN AIR FLITER
To ensure efficient operation of the air conditioner, clean the air filter after each week of operation.
1.
Before cleaning, switch off the appliance, wait a few
minutes and then unplug the appliance to disconnect it
from the mains.
2.
Pull off the exhaust hose.
3.
The air conditioner has a total of 2 air filters:
Open the two air inlet grilles on the back
and remove the filter underneath, as
shown in the picture:
4.
To remove the dust accumulated in the air filters, use a
hoover.
5.
If the air filter is very dirty, you can immerse it in hot water
and rinse it several times - however, the water temperature
should not exceed 40°C.
6.
After washing, allow the air filter to dry out well and then
replace them.
MAINTENANCE AND CLEANING
NOTE
Never use the appliance without a filter.
139
Symbolic image
